NEW KIT OPTIONS NOW AVAILABLE - Purchase a kit to get the product with application pads and degreasing Prep Fluid solution or buy just the coating, the choice is yours!
15ml kit comes with 100ml Pre Fluid degreaser and 2 application pads.
30ml kit comes with 100ml Prep Fluid degreaser and 4 application pads.
50ml kit comes with 100ml Prep Fluid degreaser and 6 application pads.
100ml kit comes with 250ml Prep Fluid degreaser and 8 application pads.
250ml kit comes with 500ml Prep Fluid degreaser and 12 application pads.
The Ceramic Warehouse Matte, Wrap & PPF Ceramic Coating is an advanced solution that provides unmatched protection for your vehicle's vinyl wrap, matte paint, and paint protection film. Made with state-of-the-art ceramic technology, this coating creates a hydrophobic and oleophobic layer on your vehicle's surfaces, making them incredibly resistant to water, dirt, and other contaminants.
Unlike traditional coatings, this ceramic coating is designed to maintain the unique look and texture of your vehicle's wrap, PPF or matte paint. The coating provides long-lasting protection against UV rays, environmental contaminants, and other types of damage.
The Matte, Wrap and PPF Ceramic Coating is also incredibly durable, with a lifespan of up to 3 years, depending on usage and environmental conditions.
By protecting your vehicle's wrap, PPF or matte paint with our ceramic coating, you're investing in long-term protection that will keep your vehicle looking great for years to come!
Matte, Wrap & PPF Ceramic Coating
APPLICATION:
- Take a fresh application pad and dampen with the ceramic coating until it is wet, but not dripping.
- Coat one area or up to 2 square metres at a time, ensuring on each panel to work horizontally, then vertically, for an even spread of product (also known as cross-hatching).
- The area should look wet and have a rainbow appearance after approximately 30 seconds to 1 minute.
- After a minimum of 1 minute, but not exceeding 2 minutes take a clean microfiber cloth and go back to the point where coating started.
- Now gently buff all the areas that have been coated in order to remove the excess residue, until a uniform streak free appearance is achieved. Ensure the buffing process is light and only excess residue is being removed.
- Use a second micro fibre cloth for complete residue removal for a quality finish.
- Once you have finished buffing, repeat the process continuing as above.
TIP – If the product has been left on for too long and is difficult to remove, re-wet the area with an application pad and instantly buff with a microfiber cloth. Do not allow to cure with streaks and rainbows!
